AC20D-40D-A (FRL), nuovo modello modulare, filtro regolatore + Microfiltro disoleatore(Elenco numeri di parte: 2 pagina)

Air Combination, Filter Regulator + Mist Separator, AC20D-A to AC40D-A Detailed Example

AC20D-A product image

AC40D-A product image

How to Order Air Combination, Filter Regulator + Mist Separator, AC20D-A to AC40D-A

Model number example

How to order: image 1

How to order: image 2

• *1: Options G and M are not assembled and are supplied loose at the time of shipment.
• *2: When pressure is not applied, condensate which does not start the auto drain mechanism will remain in the drain bowl. Therefore manual release before ending operations is recommended.
• *3: If the compressor used is small (0.75 kW, discharge flow rate is less than 100 L/min [ANR]), air leakage from the drain cock may occur when operations start. An N.C. type is therefore recommended.
• *4: When the pressure gauge is attached, a 1.0‑MPa gauge will be fitted for the standard (0.7‑MPa setting) type; and a 0.4‑MPa gauge for the 0.2‑MPa type.
• *5: The bracket position varies depending on the pressure switch mounting.
• *6: Make sure that the outlet pressure is released to atmospheric pressure using a pressure gauge. For the V1 specification, use the regulator with a set pressure of 0.15 MPa or more to ensure the pressure release.
• *7: Pressure can be set higher than the specification pressure in some cases, but use with the pressure within the specified range.
• *8: Does not include a valve function.
• *9: Thread type NPT is applicable. Under new Japanese measurement laws, this product is only available for sale outside of Japan (SI units are used in Japan).
  However, the pressure switch offers dual unit presentation in both MPa and psi.
  Round-type Pressure Gauge (with Color Zone): cannot be used in combination with M. Available on request as separate, special order from the manufacturer.
• *10: ○ is for thread type NPT only.
• *11: Metal bowl: Cannot be selected in combination with 2, 8.
• *12: Float type auto drain: Cannot be selected in combination with C, D.

Standard specification

• *1: Conditions: Mist separator inlet pressure is 0.5 MPa. The rated flow varies according to the inlet pressure.
  Keep the air flow within the rated flow to prevent an outflow of oil to the outlet side.
• *2: At compressor discharge concentration 30 mg/m³ (ANR)
• *3: The bowl seal and other “O”-rings use a small amount of grease.

Dimensions: Air Combination, Filter Regulator + Mist Separator, AC20D-A to AC40D-A

AC20D-A

AC20D-A dimensional drawing

AC30D-A to AC40D-06-A