MHCM2, pinza pneumatica, tipo apertura a fulcro, tipo piccolo (MHCM2-7S-X4)

Angular Type Air Chuck, Compact Type, MHCM2-7S Series Specifications

MHCM2-7S Series JIS symbol (single acting normally open, external gripping)

Applicable fluids	Air
Operating pressure	0.4 to 0.6 MPa
Ambient temperature and working fluid temperature	-10 to +60°C
Repeat accuracy	±0.02 mm
Maximum operating frequency	180 c.p.m.
Lubrication	Non-lube
Operating method	Single acting (normally open)

Outline dimensional drawing

(Unit: mm)

MHCM2-7S dimensional drawing

Structural drawing

Single acting type / open condition structure drawing

Closed condition structure drawing

Component parts

Effective Gripping Force

Expressing the effective gripping force

The effective gripping force shown in the graphs below is expressed as F, which is the thrust of one finger when both fingers and attachments are in full contact with the workpiece as shown in the figure below.

Finger thrust: F diagram

L: Gripping point length dimensional drawing (external gripping)

Effective gripping force graph

*If there is an overhang, please consult with the manufacturer.

Precautions

Mounting

1. *1Tighten the screw within the specified torque range when mounting the air chuck.
   Tightening with a torque above the limit can cause malfunction, while insufficient tightening can cause slippage and dropping.
2. *2Do not scratch or dent the air chuck by dropping or bumping it when mounting.
   Even slight deformation can cause the deterioration of accuracy and operation failure.
3. *3Tighten the screw within the specified torque range when mounting the attachment.
   Tightening with a torque above the limit can cause malfunction, while insufficient tightening can cause slippage and dropping.

Other precautions

• *Note the risk of corrosion on the finger. Except for certain models, the finger uses martensitic stainless steel, whose corrosion resistance is inferior to austenitic stainless steel. In particular, rust may occur in environments where water droplets adhere to the unit due to condensation.
• *See the manufacturer's catalog for product information other than the above.